FAQ

/FAQ

HOW TO FIX:

Lower the beverage temperature, turn the thermostat to the right.

Clean the system

Reduce the flow level by turning the flow tap down.

CAUSE:

Loose connections

HOW TO FIX:

Pull out the tube, check for any sharp edges, and if there are, cut with knife. Tighten the nuts on the keg coupler. With kprofi models check the pressure on the manometer

HOW TO FIX:

Switch the button on the cooler.

Turn the adjustment screw to the right (kprofi models)

CAUSE:

The pressure is too high

HOW TO FIX:

Lower the pressure in the keg

CAUSE:

Setting of the thermostat is not correct.

Bad air circulation

The machine is overheated

HOW TO FIX:

Turn the thermostat to number 7

Check and remove anything that is blocking airflow

Put the machine into colder surrondings

CAUSE:

The keg is connected incorectly.

Not enough air or gas pressure

The water froze after sanitation

Closed ccompensator(small flow tap on the side of the main tap)

HOW TO FIX:

Check if keg coupler is connected and the handle is down.

Use a compressor to pump air into the keg

Co2-check the pressure and adjust.

Switch of the machine and wait until the beverage starts to flow again.

Move the small lever on the ecompensator

CAUSE:

The tube is not inserted correctly

Tube damged

HOW TO FIX:

Pull out the tube , check for any sharp edges, if found remove with sharp knife

Pull out tube and shorten by 2 cm

CAUSE:

Ventilation grid is covered

The machine has a dirty condenser

HOW TO FIX:

Remove anything that is covering the ventilation grid

Remove the course dirt and wipe off the dust

CAUSE:

The power cable is not connected

Socket does not work

The main switch is not turned on or the thermostat is set to “0”

HOW TO FIX:

Connect the power cord to the socket

Get the socket repaired by electrician

Turn on the power switch and set the thermostat to the desired level

CAUSE: There is a fallen object in the machine

There is a fallen object in the fan area

HOW TO FIX:

Turn off the machine and remove the object

Turn off the machine and remove the object from the fan area